Montana
REGULATIONS, RECOMMENDATIONS & GUIDELINES


Weigh Scales for Monitoring Water and Wastewater Treatment Chemicals
 


MONTANA DEPARTMENT OF ENVIRONMENTAL QUALITY
Standards For Water Works
"Weighing scales 1. must be provided for weighing cylinders, at all plants utilizing chlorine gas, 2. may be required for fluoride solution feed, 3. should be provided for volumetric dry chemical feeders"

MT_W_DEQ.pdf

 
MONTANA DEPARTMENT OF ENVIRONMENTAL QUALITY
Standards For Wastewater Facilities
"Scales for weighing cylinders must be provided at all plants using chlorine gas. At large plants, scales of the indicating and recording type are recommended."

MT_WW_DEQ.pdf

 
CENTER FOR DISEASE CONTROL (CDC)
Engineering and Administrative Recommendations for Water Fluoridation, 1995

"Day tanks or direct acid-feed carboys/drums should be located on scales; daily weights should be measured and recorded. Volumetric measurements, such as marking the side of the day tank, are not adequate for monitoring acid feed systems."

"Scales must be provided for weighing the amount of chemicals used in the dry feeder."

CDC_Fluoride.pdf

 


AWWA MANUAL M4:
Water Fluoridation Principles and Practices, Third edition:

"In any fluoridation installation, except one based on a sodium fluoride saturator, scales are necessary for weighing the quantity of dry material to be used in preparing the solution, the quantity of solution fed, or the quantity of fluoride compound or hydrofluosilicic acid delivered by the appropriate feeder." -Page 26

"Alarms: To prevent underfeeding or loss of feed, alarm systems can be included in either solution or dry feed systems. The alarm alerts the operator when the level of solution in the day tank is low or when it is time to add chemical." -Page 30


 
THE CHLORINE INSTITUTE
Pamphlet 1, "The Chlorine Manual"

"Weighing-Because chlorine is shipped as a compressed liquefied gas, the pressure in a container depends on the temperature of the chlorine. The pressure is not related to the amount of chlorine in the container. Container contents can be determined accurately only by weighing." –Page 10, Section 2.8.4

 
COMPRESSED GAS ASSOCIATION
CGA G-2 Manual

"Determining when cylinders are empty-Weighing. The best way to determine if an ammonia cylinder is empty is to weigh it, without cap, and compare the weight with the tare weight stamped on the cylinder." -Page 36, Section 8.9.1

 


These documents may not represent a complete list of regulations, recommendations or guidelines. Always consult your local agencies to determine which specific guidelines, recommendations or regulations affect your water or wastewater treatment operation.




Headquarters: 2430 Stanwell Drive, Concord, CA 94520 U.S.A. Phone: (800) 893-6723 or (925) 686-6700 Fax: (925) 686-6713
jordan 6 sport blue legend blue 11s foamposites black suede jordan 6 black infrared foamposites black suede legend blue 11s legend blue 11s black infrared 6s black infrared 6s louis vuitton outlet sport blue 6s jordan 11 legend blue black toe 14s black infrared 6s jordan 11 legend blue legend blue 11s cheap oakley sunglasses jordan 6 sport blue jordan 11 legend blue jordan 11 legend blue jordan 6 jordan 6 jordan 11 legend blue louis vuitton outlet lebron 12 jordan 11 legend blue jordan retro 11 coach factory outlet lebron 11 legend blue 11s jordan 6 black infrared legend blue 11s jordan 6 black infrared legend blue 11s coach factory outlet sac louis vuitton cheap jordans Legend Blue 11s louis vuitton outlet jordan retro 11